Feature

●Tools for plastic models
●Plastic round rod core (end), hand machined jig for straight holes on the sides
●For 0.04 inch (1 mm) diameter drill blades, if you want to drill a hole smaller than 0.04 inch (1 mm) diameter, please use a drill blade with a small diameter blade on the tip with a 0.04 inch (18 mm) shaft (to finish the core and end)
●For precision processing, the plastic rod itself can be adjusted to the specified size. Example: When using a 0.08 inch (2.0 mm) hole, it can be adjusted to 0.08 - 0.08 inch (2.00 - 2.05 mm)
●When using for the first time, the hole for the drill is required to pass through the holes. Insert 0.04 inch (1 mm) size drill to remove the excess plating thickness inside the drill hole
●Using the specified size drill blade may result in cutting the inner wall of the hole to reduce accuracy, and the blade will not fall out
●Please be aware that there may be scratches on the surface that are not affected by use


Description

Hand Machined Jig
Assists with drilling 0.04 inch (1 mm) diameter holes on the end and sides of the round rod.
Compatible with plastic round rods of 0.08, 0.16, 0.2 inch (2, 3, 4, 5
Plastic round rod core (end) and straight hole jig on the side
For 0.04 inch (1 mm) diameter drill blades.
If you want to drill a hole smaller than 0.04 inch (1 mm) in diameter, please use a drill blade with a small diameter blade at the tip (but for the core and edge processing, the total length of the blade is 0.7 inch (18 mm) or more).

Product Specifications
Product Size (W x D x H): 1.0 x 1.3 x 0.3 inches (25 x 3
Material: Brass (nickel plated)
Processable Material: Plastic
Country of Manufacture: Japan

For precision processing, please match the plastic rod itself with the specified size. For example: 2.0mm hole can be up to 2.00-2.05mm
When using for the first time, you will need to pass through the holes for the drill. Insert a 0.04 inch (1 mm) size drill to remove excess plating thickness inside the drill hole.
Always use the specified size drill blade. The inner walls of the hole may be shaven, reducing accuracy, and the blade will not fall out.
There may be some scratches on the surface that are not affected by use. Please acknowledge

This product is a tool for plastic models.
"Plastic Model" is a registered trademark owned by the Japan Plastic Model Industrial Cooperative Association.

(From )