Feature

●Compatible with T-Rex 250-800 TGZ580 Flybarless Syetem helicopters of all sizes
●Functions and uses are similar to MB PLUS PRO 4.20
●Function: Altitude control (one key rescue)
●TGZ580 can not upgrade firmware

Description

Description

This product is compatible with various sizes of T-Rex 250-800TGZ380 Aeronless Helicopter. Small and exquisite, powerful, 5 modes.

Specifications:

Brand: ALIGN VWINRC

Item Number: TGZ580

Product: 3-Axis Gyroscope

Size:35*25*14MM

Net Weight: Approx. 10.8

Application: For T-Rex 250-800RC Helicopter

Note:

Remote control must open 7th channel to enable altitude control (gyroscope default is 7th channel as rescue channel).Rescue must be a single line receiver (SBUS, PPM, SRXL, satellite reception)

Altitude control function has 5 modes.

1. First aid correction mode: only correction can control the PTCH At this time, all the pole input is effective, and the more poles you play, the smaller the rotational function will be.

2. First Aid PITCH: Correct PI TCH control.The aircraft can bend to the right, and the aircraft can be lowered and only rised.

3. 3D Mode: Recognize whether the aircraft is upside down or upright, and point to the nearest horizontal hovering height().This PITCH is controllable.

4. 3D PI TCH Mode: Rotate to the nearest horizontal hover (forward or backward) to control the PI TCH to prevent the aircraft from falling off.With remote input, you can only raise the aircraft.

5. Trainer Mode: Even if you shake the joystick too wide, the rotation angle of the aircraft will be limited, and the aircraft will not be vertical.

Receiver Selection

The default receiver for TGZ580 is a common receiver.If you need to change the type of receiver, you need to keep pressing the TGZ580 button before turning on the receiver before connecting to the power supply.When the A-light starts blinking, release the button to enter the receiver. Type selection mode.

Step 1: Hold the set button and hold the button to turn on the receiver

Step 2: Release the button Release button A: Flash status LED: Off(Press and hold button for 3 seconds)

Step 3: Short Acupressure Release Button Status LED: Off (Purple Red Flashing)

Step 4: Short press button B: Flash status LED: Blue (hold button for 3 seconds)

Step 5: Long press the button and press the button N: Flash status LED: Red-Blue (hold button for 3 seconds)

Step 6: Long press the button. Press the button A-N: Flashing status LED: Off

Disconnect and turn on again

*Before setting up, the remote must use 90 degree traditional slash plate mode, mixing control mode cannot be used.Normally choose H-1 or 1 servo mode.*Remote control keeps pitch curve in factory condition, so please do not adjust the pitch curve before setting the gyroscope.*Turn on the remote control first, then turn on the aircraft.Initialization process after turning on the power to keep the aircraft stationary.