[100×70×30mm 1 piece]
[200×150×30mm 1 piece]
[1 sheet]
ActiveIsland A103 Cork Plate, Leather Craft, Cork Board, Rhombus Stand, Platform
Cork board for leather craft. Place cork underneath when drilling holes in leather
Used to penetrate from top of the rabbard.
You may be wonder why you use it, but the holes are sewn with thread.
There are two disadvantages, though some people can open it with the diamond. Rhombus Perforated
It is striking, so it is noisy and noiseless.
It is easy to get in the way. Of course, there are also good points.
When using a diamond grinder, you mainly mark the hole with a diamond grain, and then you can use a rhombus to make a hole
When opened, you can lay it on a cork board and it will not hurt the tip of the penetrated area. Of course,
There are rubber plates etc. when drilling, but they are too hard to damage the edge. It is too strong
It will penetrate through the process, so you will be able to do just a few times.
This is a dedicated leather craft product, so it has just the right amount of firmness. The leather sinks in when you bite it.
No Easy to remove when unplugging Rhombishi sounds like a "zu" when you bite.
of the round end. Take care of it. Also, do not use the same place.
We think it will last you a long Use this set for people who consider rhombus tears as noise countermeasures.
Hope you can understand.
Size: 1 piece: 5.9 x 5.9 x 0.6 inches (150 x 150 x 15 mm); 2 pieces: 5.9 x 5.9 x 1.2 inches (150 x 150 x 30 mm); Weight: 1 piece 3.5 oz (100 g).
You can easily enjoy a world of hobbies that you can easily enjoy the deep back of your wallet or key case.
Have fun!