Feature

●The 150 air shovel is suitable for removing sand from small casts, slopes before welding and welding slugs after welding. Flat welding scratch and rust removal head can be used to remove rust on uneven surfaces of mechanical equipment. Rusted equipment, easy construction and high efficiency
●Removes rust from car muffler pipes, metal sheet metal curls, and welded slags. Automotive Industry Exhaust Pipes, Sheet Metal Decorative Construction, Wall Sloting, Embedded Cement plants cement plant fixtures and filling trucks knock down cement blocks, etc
●Suitable for paint, automotive repair, hardware, ceramic lighting, masonry, wall processing (construction industry), craft engraving and polishing. and other operations
●The 150 Air Shovel Air Inlet Filter is designed to effectively filter impurities and prevent the stone from entering the torso and damaging the machine. Can only be used when connected to common air pipes possible
●The intake port of 150 air shovel also has an air oil filling hole. Inject 2-3cc of pneumatic lubricant before and after daily use. After filling the oil, run the machine for a few seconds


Description

Use the appropriate pressure
For 150 air shovels, please use gas in a range of 14.4 - 17.6 lbs (6.0 - 8.0 kg/ cm2). When the air pressure is too low, the working efficiency tool will significantly reduce or work normally. If the air pressure is too high, it can improve the working efficiency of the tool, but it is easy to damage the internal components and shorten the lifespan of the tool.
Use the filter
150 air shovels compressed air moisture, dust, rust and other foreign substances are the main cause of premature aging of pneumatic tool parts. Required to install the filter. The tools should be filtered in the air to provide a clean, dry gas. Filters need enough flow, they must be cleaned frequently, otherwise the flow is insufficient, which will affect normal operation. In addition, after the air compressor is working for a certain period of time, a large amount of water accumulates inside and must be discharged regularly to ensure that the gas is dry.
Tool Lubrication
150 air shovels must be lubricated regularly and properly to ensure normal and long term work. The correct lubrication method is achieved through the "3-piece combination" device (water and petroleum grid). As air flows through the water and oil grid, the lubricant in the oil tank will be atomized, and the choice of lubricant is very important. Wrong lubricant may damage the tool. In general, a special lubricant for pneumatic tools is used. Using concentrated engine oil is strictly prohibited. If there is no water or petroleum grid device in the way, please place 3-4 drops of lubricant in the intake of the tool before and after work daily.

No-load speed
4500 (RMP)
Air Consumption
5.