Description:
1. Easy to install with fixed bolt holes.
2. The sensor can detect changes in the angle of the body.
3. Comparator output, signal clean, good waveshape, high driving capacity of more than 15 ma.
4. Use high sensitivity switch SW-520D as angle sensor. Uses a wide voltage LM393 comparator.
Specifications:
Operating Voltage: 3V-5V
Output format: Digital switch output (0 and 1)
Small board PCB size: 1.5 x 0.5 x 0.3 inches (37 x 14 x 7 mm)
Total length: 2.0 inches (51 mm)
Package Include:
5 x Angle Sensor Module
Usage:
1. The output of the switch module depends on the angle the switch is turned on/off. When the angle is off, the DO output is high, the angle switch is on, and the DO output is low.
2. The output is connected directly to the microcontroller via the microcontroller to detect high and low to detect the angle change.
3. The output of the module can drive the relay directly.
Module Wiring Instructions:
1. VCC: Power supply.
2. GND: Power -
3. DO:Digital signal output
4. AO: This function is disabled with this vibration sensor.
Purchasing electronic components requires a basic knowledge of electronics. Most modules provide description or information only. No technical consultation support. Beginners should be careful.