Cow Media offers a variety of solar sets.
■ Basic set of solar panel, charge controller, solar extension cable, battery connection cable
■Solar battery set with deep cycle battery
- Solar inverter set with AC 100V converter for household power supply, for staying in your car, in case of emergencies, or disasters.
When connecting an inverter, please be sure to connect directly from the battery.
■ For charging the battery of the electric fence to protect fences from wild crops and other pests such as boars, there is a set of solar electric fences.
Please use directly from the battery depending on the power of the electric fence.
For more efficient solar power, we recommend placing it in a location with good sunlight conditions.
The average direction of Japan is normal; Angle: about 30 to 35 degrees.
The charging controller and cable are prone to deterioration due to UV rays and rain water, so please use it as a precaution to avoid rain and water.
|
|
|
---|---|---|
Step 1Firstly, prepare a battery cable, charge controller, loosen the screw on the battery connection of the charge controller, insert the battery cable to the "++ for red wire", and then tighten it to connect it. |
Step 2Install the battery cable to your battery (included battery set) |
Step 3When the connection is complete, the "Charge Controller" LCD will be displayed. Note: If the LCD is not turned on. The battery voltage may be too low (about 11 V or less) Fully charged with a battery charger on a household power source (or resume voltage above about 12.6 V). 24 V set doubles |
|
|
|
---|---|---|
Step 4After confirming that the charge controller is working properly, prepare the solar extension cable, loosen the screw on the solar panel connection of the charge controller, plug and reconnect it. |
Step 5Connect the cable from the back of the solar panel body to the black connector of the solar extension cable. The connectors are paired and the cable is constructed with the same color. |
Step 6If the solar panel is fully charged, it will change to the solar panel and the sun mark at the top left of the LCD screen.(month mark when not connected or not charged) The charge controller is a device that can be installed to prevent overcharging, overdischarge, and backflow in addition to converting the battery to the appropriate charging voltage. Please note that it will work with the power of the battery, so if the voltage falls too low, it will not work properly and does not charge by solar power. |