The XTAR MAGNEMITE H3R is a headlight that boasts a maximum luminous flux of 1000 lumens that is truly bright as the sun. Simply click the electronic switch to select the brightness you desire.With a light hit magnetic charge, you can step into a new Shining World. Rechargeable batteries are compatible with 3 types of 1 x 18650 / 2 x 16430 / 2 x CR123A so you can immediately light the battery when you grab it.In addition, it has memory function in the light mode, lock up function to avoid accidental light, temperature monitor function that prevents overheating, and flashes to notify you that the battery is low. The H3R will be the best headlamp for you.

LED Cree XP-L V6 Battery 1 x 18650/2 x 16340/2 x CR123A (Not Included) Switch Click Mode *Nominal Value Turbo 1000 Lumens High 500 Lumens Mid 240 Lumens Low 60 Lumens Moonlight 5 Lumens (Actual Approximately 3 Lumens) SOS 500 Lumens Maximum Luminous Intens) (*Full moon Distance: 392.8 ft (150 m) Shock Resistant 1.5 m Water Resistant ANSI IPX7 (1 meter depth, 30 minutes) Body Material 6N03 aviation aluminum alloy Hard Anodized Type III (HA3), Anti-corrosion treatment Dimensions and weight 106.4 mm x 26.7 mm 55 grams (body only)

Click the on/off switch once. Mode Selection: Moonlighter, Low, Mid, and High, when the switch is on, it will be switched sequentially. Turn on with Moonlight; When the switch is turned off, the Moonlight will turn on. Double click the switch within 1 second, regardless of whether the Turbo is on or off. Triple click the switch whether the SOS is on or off.Then a single click will turn off. Lockout Mode: When the switch is turned off, the Moonlight will light up, and if you continue to turn it off and enter lockout mode. Press and hold the switch to release.While you press the Moonlight will light up, and once flash, it is a signal. Load the charging 18650 in the correct direction (+ pole is the head side) into the H3R and connect the included USB magnetic cable. If the lamp is red, it is charging and green then charging is complete. When charging, please make sure that the rechargeable battery is rechargeable 18650. Remove the H3R tail cap that is inserted into the headband, remove the rechargeable battery, and insert the H3R into the rubber of the headband. Then load the rechargeable battery with the + pole toward the head and tighten the tail cap. Note: 1. Please take out the batteries if you are not using them for a long time. 2. When the battery voltage is less than 3V, the H3R will lower the lighting mode level.In this case, it will not light up in bright mode unless the battery is not sufficient power. 3. When the H3R flashes 3 times, the remaining battery is low, so please charge it.The maximum charging current of the USB magnetic cable is 1A.When charging with a USB magnetic cable, make sure that the rechargeable battery is 18650 lithium-ion rechargeable battery. 4. In Turbo mode, if you turn it on for 3 minutes, the brightness will be reduced to 60% to avoid overheating. 5. Make sure the positive pole of the battery is facing towards the head side. 6. Make sure the tail cap is tightened tightly.If it is loose, it will not connect electricity. 7. Do not wipe with strong corrosive substances.

H3R Stainless Steel Clip Headband Helmet Clip USB Magnetic Cable Manual