Convenient tool

(1) Plastic Model Nipper: Use a thin blade nipper for plastic model that is easy to cut from runners (gate).

(2) Utility Knife: You can use a regular cutter, but with a design cutter, you can increase the accuracy of your product.

(3) Tweezers: Use to grab small parts that are difficult to handle with your fingers.

(4) Glue for plastic model: Top poured type, bottom is normal.Regular adhesive is applied to the adhesive surface before assembling, but the poured type is assembled and then touching the brush tip to the adhesive side of the part and the part will flow through the surface tension.

Caution for using glue: Do not expose to open flames, and contains organic solvents, so if you inhaled too much, it will not be good for your body.Please be careful when ventilating.

How to cut from runners:

(1) When removing parts from the runner, do not cut it off at once, leaving a little bit of the gate and trim it with a nipper/cutter.

(2) Carefully cut the remaining gate

How to attach: For small adhesives it is difficult to apply regular adhesive to glue, so it is recommended that you first combine it and use a poured type of adhesive in the gap.

About the paint

For those who want to smooth finish the paint peeled off after the gate cut marks, etc., paint for plastic models.Plastic model paints are divided into large quantities, including lacquer, water-based acrylic, and enamel. Each one is short and long.

(1) It is recommended for water-based acrylic paints that have a low odor and have a good color that is easy to brush on.

(2) Suitable for marking and staining paint with enamel paint that is difficult for villages to come out.

Paint Precautions: Do not expose to open flames, contains organic solvents, so if you inhale, it will not be good for your body.Please use caution when ventilation.

Trim Off Decal

(1) Using the instructions included with your order, find your decal and position to apply, and cut out the decal you need.

(2) Soak the cut decal in water.(Because the decal may fall apart in too cold water, it is recommended to use warm water especially in winter.)

Apply the decal

(3) Soak it a little bit and remove it and let it sit for a while.Once you see that your decal glides over the backing paper, grab the decal with tweezers and place it in place.Use a cotton swab to remove water or air from the decal and wait for it to dry.

(4) If the decal does not stick properly, use a marksetter (decal glue).To use, apply the decal to the area you are applying and then place the decal on top.

Finished

Above are instructions on how to assemble the EFTS toys.

Before assembly, check all parts and see the assembly instructions for the assembly.